Headlights Assembly for 2005-2011 Toyota Tacoma Black Amber Headlamps Left+Right

Description

Document
Features:
OEM PART NUMBER: TO2502157, TO2503157, TO2503181, TO2503181
Interchange Part Number: 8115004163, 8111004163, 8115004173, 8111004173
SAE/DOT approved for street legal
Made By OEM Approved & ISO Certified Manufacturers With Materials That Meets OEM Requirements
High Beam Bulb Type:
H4 (bulb not included)
Low Beam Bulb Type:
H4 (bulb not included)
Turn Signal Bulb Type:
4157A (bulb not included)
Position Light Bulb Type:
W5W (bulb not included)
Description:
Gives you and your family safer nighttime driving and
see road markings and traffic sighs better.
Driving at night can be a scary proposition - and it's even scarier if you can't see the road well.
A dim, cloudy, yellowed, or otherwise damaged or non-functioning headlight makes driving dangerous,not only
is
your own
safety at risk, but the safety of others is as well.
High Sealing:
Good enough to avoid any water issue.
Exactly Right Position:
All the new assemblies
popped right into place
and
lined up with the mounting bolts exactly right
Good Fitment:
Perfectly fit 2009-2018 Dodge Ram 1500/2500/3500 Black Quad
Excellent Packing:
Each assembly was sealed in its own fitted box,
with a cellophane protectant on the outer plastic and paper
seals covereing the access
ports for the bulbs
Fitment:
For 2005 2006 2007 2008 2009 2010 2011 Toyota Tacoma
Package Includes:
Pair LH(Left Hand)&RH(Right Hand) Headlight Assembly
For 2005-2011 Toyota Tacoma
Installation:
1).How to install:
1.Undo the screws, clips, or retainer springs that hold the headlight in place.
2.Disconnect the wiring from the assembly.
3.Detach the headlight from the vehicle to replace it with a new one.
4.Fit in the new headlight assembly.
5.Fix the new headlight into place and make sure that the screws, clips, or retainer springs used are sealed.
6.Reconnect the wiring that was unplugged from the assembly.
7.Put back the grille and other components that you removed. Seal them back into place.
8.Test the new assembly.
2).How to adjust:
Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to 25 feet from the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than 3.5 feet above the ground.
1.
Find the adjustment screws.
Firstly, locate the adjustment screws on your vehicle.
2.
Adjust the headlights individually.
The headlights should be adjusted one at a time. Put a rag or towel over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens.
3.
Adjust the vertical field.
The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall.
4
.
Test your results.
WE ACCEPT THESE PAYMENT METHODS
( 10% sales tax will be applied for orders shipped to Washington state by state law )
30 Days easy returns satisfaction guarantee.
Items to be returned must be in original factory condition.
Please enclose a note about item number and order id, your eBay ID and the reason of return.