-40%
For 2000 2001 2002 2003 Nissan Sentra Headlight Factory Style Black Housing Pair
$ 32.74
- Description
- Size Guide
Description
funsport-usaDESCRIPTION:
A new pair of headlights from ours allow you to see the road in front of you clearly during the night and in any bad weather
that may arise.
Gives you and your family safer nighttime driving.
Makes your car looks newer.
See road markings and traffic sighs better.
Driving at night can be a scary proposition - and it's even scarier if you can't see the road well.
A dim, cloudy, yellowed, or otherwise damaged or non-functioning headlight makes driving dangerous,not only is your
own
safety at risk, but the safety of others is as well.
APPLICATION:
For 2000 2001 2002 2003 Nissan Sentra
4Dr SE-R
SPECIFICATION:
High Beam: 9007
Low Beam: 9007
Turn Signal:
3157A
Black Housing Clear Lens Amber Reflector
FEATURES:
SAE/DOT approved for street legal.
High grade ABS plastic: for toughness, impact resistance, and heat resistance.
Plug-n-play installation: fully compatible as replacement for factory parts.
Bulbs NOT included, should reuse original bulbs.
PACKAGE INCLUDES:
2pcs LH (Driver Side) & RH (Passenger Side) headlights
NOTE:
Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to 25 feet
from the wall with the lights aimed at the wall. The center lines of the headlights should not be any higher than 3.5 feet above
the ground.
1.
Find the adjustment screws.
Firstly, locate the adjustment screws on your vehicle.
2.
Adjust the headlights individually.
The headlights should be adjusted one at a time. Put a rag or towel over a chair in front
of the light you want to block. Covering the light assembly directly can damage the plastic lens.
3.
Adjust the vertical field.
The screw on the top of the light housing should be turned clockwise to raise the lights and
counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam
shines directly on or just below the center of the tape line on the wall.
4.
Adjust the horizontal field.
The screw on the side of the light housing should be turned to get the right/left adjustment
correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.
5.
Test your results.
On Apr-20-21 at 02:17:16 PDT, seller added the following information: