-40%
for 00-05 Chevy Impala Chrome Clear Amber Headlights Headlamps Assembly Pair Set
$ 42.16
- Description
- Size Guide
Description
DESCRIPTION:A new pair of headlights from ours allow you to see the road in front of you clearly during the night and in any bad weather
that may arise.
Gives you and your family safer nighttime driving.
Makes your car looks newer.
See road markings and traffic sighs better.
Driving at night can be a scary proposition - and it's even scarier if you can't see the road well.
A dim, cloudy, yellowed, or otherwise damaged or non-functioning headlight makes driving dangerous,not only is your own
safety at risk, but the safety of others is as well.
Low Beam Bulb Type: 9006 HB4 (bulb not included)
High Beam Bulb Type: 9005 HB3 (bulb not included)
COMPATIBLE WITH:
FOR 2000-
2005
Chevy Impala
FEATURES:
Chrome Housing Clear Lens Amber Reflector
DOT & SAE for street legal
Great Replacement or upgrade for factory headlights
Adjustment screws for high/low beam
PACKAEG INCLUDES:
1 pair set of Left Driver Side + Right Passenger Side Headlights Headlamps
FOR 2000-
2005
Chevy Impala
NOTE:
Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to 25 feet
from
the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than 3.5 feet above
the
ground.
1.
【
FIND THE ADJUSTMENT SCREWS
】
Firstly, locate the adjustment screws on your vehicle.
2.
【
ADJUST THE HE
ADLIGHTS INDIVIDUALLY 】
The headlights should be adjusted one at a time. Put a rag or towel
over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens.
3.
【
ADJUST THE VERTICAL FIELD
】
The screw on the top of the light housing should be turned clockwise to raise the
lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the
light beam shines directly on or just below the center of the tape line on the wall.
4.
【
ADJUST THE HORIZONTAL FIELD
】
The screw on the side of the light housing should be turned to get the right/left
adjustment correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.
5.
【
TEST YOUR RESULTS】