Black For 2007-2013 GMC Sierra 1500 2500 3500 Headlights Headlamps Left+Right US

Description

funsport-usa
Feature :
A new pair of headlights from ours allow you to see the road in front of you clearly during the night and in any bad weather
that may arise.
Gives you and your family safer nighttime driving.
Makes your car looks newer.
See road markings and traffic sighs better.
Driving at night can be a scary proposition - and it's even scarier if you can't see the road well.
A dim, cloudy, yellowed, or otherwise damaged or non-functioning headlight makes driving dangerous,not only is your own
safety at risk, but the safety of others is as well.
Black Housing Clear Lens with amber reflector
SAE/DOT approved for street legal
High grade ABS plastic: for toughness, impact resistance, and heat resistance.
Plug-n-play installation: fully compatible as replacement for factory parts.
High Quality: Fully sealed, waterproof, dust and corrosion resistant, works perfectly even in harsh weather conditions.
Bulbs are NOT included, need to reuse original bulbs.
Fits for :
Fit
2007-2013 GMC Sierra 1500
Fit
2007-2014 GMC Sierra 2500 HD
(Don't compatible with 2500 HD classic)
Fit
2007-2014 GMC Sierra 3500 HD
Specification :
High Beam Bulb Type: 9005/HB3
Low Beam Bulb Type: H11
Turn Signal Light Bulb Type: 3157A
Packing list :
1 Pair LH (Driver Side) & RH (Passenger Side) headlights with amber reflector
Please note :
Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to 25 feet
from
the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than 3.5 feet above
the
ground.
1.
【
FIND THE ADJUSTMENT SCREWS
】
Firstly, locate the adjustment screws on your vehicle.
2.
【
ADJUST THE HE
ADLIGHTS INDIVIDUALLY 】
The headlights should be adjusted one at a time. Put a rag or towel
over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens.
3.
【
ADJUST THE VERTICAL FIELD
】
The screw on the top of the light housing should be turned clockwise to raise the
lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the
light beam shines directly on or just below the center of the tape line on the wall.
4.
【
ADJUST THE HORIZONTAL FIELD
】
The screw on the side of the light housing should be turned to get the right/left
adjustment correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.
5.
【
TEST YOUR RESULTS】